Fault analysis on a naval power grid using equivalent impedances

Access full-text files

Date

2004-07

Authors

Davey, K.R.

Journal Title

Journal ISSN

Volume Title

Publisher

IASME

Abstract

Generation High Speed Rail Program. The flywheel rotor, which weighs 5100 lb, is designed to store 130 kW-hr of energy at a top design speed of 15,000 rpm. The vertical rotor, which runs in a vacuum, is supported by a 5 axis magnetic bearing system. The flywheel housing is gimbal mounted to isolate the vehicle chassis from the gyroscopic forces in this dynamic application. A high speed 2 MW motor-generator, which is outside the vacuum, is directly coupled to the flywheel with the use of a rotary vacuum seal. This paper discusses the design of the magnetic bearing actuators. There are two identical radial bearings and a double acting thrust bearing, each employing permanent magnet homopolar bias fields coupled with active control coils. The bearings employ permanent magnet homopolar bias fields. Some electromagnetic design analysis of the actuators is presented, along with test results for static electromagnetic fields measured within the bearing air gaps. Measured hysteresis loss in the radial bearing laminations is also presented. Analytical estimates of actuator bandwidth are compared to measurements. A preliminary build of the flywheel rotor (the design of which is discussed in a companion paper) has been successfully spin tested to 13,600 rpm with the use of a digital bearing controller. Performance of the position sensors, fiber optic for radial and eddy current for axial, has thus far been adequate.

Description

LCSH Subject Headings

Citation

K.R. Davey, “Fault analysis on a naval power grid using equivalent impedances,” IASME Transactions, vol. 1, no. 2, April 2004, pp. 247-251.

Collections