Simultaneous propagation of multiple fractures in a horizontal well
MetadataShow full item record
As the development of shale resources continue to accelerate in the United States, improving the effectiveness and the cost efficiency of hydraulic fracturing completion is becoming increasingly important. For such improvement, it is necessary to investigate the effects of various design parameters and in-situ conditions on the resulting fracture dimensions and propagation patterns. In this thesis, a 3D geomechanical model was built using ABAQUS Standard to simulate the propagation of multiple competing fractures in a single fracture stage of a horizontal well. The reservoir was modeled as a porous elastic medium using C3D8RP pore pressure & stress elements. In addition, a vertical plane of COH3D8P pore pressure cohesive elements was inserted at each perforation cluster to model fracture propagation. Also, the flow distribution among perforation clusters was simulated using a parallel resistors model. The results suggested that the fracture spacing has the dominant impact on the number of propagated fractures. Even when all other conditions were favorable to fracture propagation, small fracture spacing reduced the number of propagated fractures. Similarly, in a given fracture stage, decreasing the number of perforation clusters abated inter-fracture stress interference, and increased the number of propagated fractures. Higher injection fluid viscosity significantly increased the fracture widths and slightly decreased the fracture lengths, but did not have any impact on the number of propagated fractures. Also, higher injection rates led to longer and wider fractures, and increased the number of propagated fractures. Therefore, a high injection fluid viscosity and a high injection rate should be used to promote fracture propagation. Lastly, higher Young's modulus of the target formation led to increased stress interference, and the resulting fractures were shorter and narrower. Therefore, if the Young’s modulus of a target formation is high, a wider fracture spacing should be considered. Through this study, a 3D geomechanical model was successfully formulated to simulate the propagation of multiple competing fractures. In addition, the effects of various hydraulic fracturing design parameters and in-situ conditions on the resulting fracture dimensions and propagation patterns were demonstrated.