Geology of El Cuervo area, northeastern Chihuahua, Mexico
MetadataShow full item record
The geologic map of El Cuervo area shows distribution of stratigraphic units ranging in age from Jurassic (?) to Recent. Outcropping strata are principally Cretaceous in mountainous areas and Cenozoic in bolson areas. From the Late Jurassic Epoch until the Late Cretaceous Epoch the Chihuahua Trough was a negative feature with respect to adjacent platforms and 10,000 to 18,000 feet of Jurassic-Comanchean sedimentary rock, including a thick basal evaporate sequence, accumulated in it; whereas on the adjacent Diablo Platform of Texas about 3,000 feet of sedimentary rock accumulated. The lower part of the Mesozoic sedimentary record shows a gradual transgression, interrupted by numerous minor regressions, from the Chihuahua Trough onto the Diablo Platform. The upper part of the record shows a regression. The eastern edge of a Jurassic (?) evaporite basin is in the eastern part of the area. Neocomian-Aptian formations are dominantly siliciclastic. Middle Albian formations are dominantly siliciclastic in the eastern part of the area, but are predominantly shallow-water carbonate to the west. Late Albian-early Cenomanian formations are limestone with subordinate shale. During the Cenomanian Epoch siliciclastic deposition again became dominant and the medial Cenomanian-Senonian formations record a transition from marine to continental deposition. Mesozoic and Paleozoic "basement" rocks were deformed during the Late Cretaceous-Early Tertiary Laramide orogeny. Jurassic (?) evaporites acted as a décollement zone between Mesozoic and Paleozoic rocks. Major thrust faults, over-thrust toward the east, developed along the eastern edge of the evaporite basin in El Cuervo area. During thrust-faulting, evaporites were diapirically injected into younger rocks along thrust- and tear-fault zones. As evaporites flowed into diapirs and cores of anticlines, blocks settled differentially into space abandoned and chaotic patterns of normal faults resulted. Olivine-diabase sills and dikes and amphibole-rich rocks (where olivine diabase was intruded into and contaminated by evaporites) may have formed during early stages of Laramide deformation. During and after Laramide deformation denudation created a surface of erosion in the area. During Early Tertiary erosion as evaporites were removed, collapse structure developed over diapirs, which had been injected along tear-fault zones. At several places in near- vertical beds on flanks of folds, as erosion removed nonresistant beds, gravity developed flaps and detached flaps in adjacent resistant beds of limestone. During late Eocene-early Oligocene time flow rocks, ignimbrites, and associated sedimentary rocks were deposited in widely scattered, topographically low areas. Volcanic and associated rocks, deposited in collapse features, were deformed as erosion of evaporites continued and they foundered into evaporites. Two porphyritic andesite intrusions are associated with Laramide faults; one is in the core of a large anticline. In the southeastern part of the area several trachyte intrusions along east-trending joints formed dikes. Subsequent to vulcanism, the region was uplifted from elevations near sea level to thousands of feet above sea level and Late Tertiary block-faulting was superimposed on Laramide structure in the eastern part of El Cuervo area. Intrusion of olivine-biotite "peridotite" may have accompanied faulting or immediately followed the main episode of faulting. Thick sections of bolson fill were deposited in the Presidio and Benigno grabens as a consequence of block-faulting. Although some Laramide faults may have been reactivated during Tertiary block-faulting, major Tertiary faulting did not take place west of the eastern front of the easternmost range of the Chihuahua Tectonic Belt.